Ölsprenkel am Heck
#26
Hier noch was offizielles zum Thema Ölverbrauch:

Q: Service Bulletin: 1999-2001: Higher Than Expected Oil Consumption
Corvette Action Center, 2002-05-17 06:46:09
A: Source: Chevrolet Dealer Service Bulletin
Number: 01-06-01-023
Subject: Higher Than Expected Oil Consumption
Model Year: 1999-2001 Chevrolet Camaro, Corvette, 1999-2001 Pontiac Firebird, with 5.7L Engine (VINs G, S -- RPOs LS1, LS6)

Condition

Some owners may comment on higher than expected oil consumption. When checked, the oil consumption could be in the range of 400-600 miles per quart (700-1000 km/L).

Cause

The cause for this condition may be an interaction between the piston rings and the cylinder bore in vehicles that are operated at higher RPMs -- typically manual transmission vehicles driven in a manner where the engine is frequently or consistently operating at greater than 3200 RPM.

Correction

A new set of piston rings is currently available through GMSPO. The new rings are part of a complete piston ring kit. Install only the number 2 compression ring and the oil expander ring from the piston ring kit. All other rings in the piston ring kit should be discarded. The original number 1 compression ring and the oil ring rails should be re-used in their original positions on the piston. All pistons should be used in the same cylinder bore.

Important

Do not dress or hone the cylinder bore. Nothing should be done to change the bore finish for this condition. Changing the bore finish may aggravate the condition.

Refer to the Unit Repair Manual for appropriate ring removal and replacement procedure.

The number 1 compression ring and the upper and lower oil expander rails are re-used because they are already broken in for the bore that they are in. The new number 2 compression ring is made with a very sharp edge that will break in quickly.

Changing only the piston rings noted, with no change in driving style, should change oil consumption to an acceptable level. Changes in driving style that reduce the amount of time spent at higher RPMs will also positively effect oil consumption.

In addition to the standard size piston ring kit listed below, a 0.25 mm oversized piston ring kit is available. The oversized piston ring kit should only be used in those rare instances where the cylinder bore size has been machined larger to accommodate the 0.25 mm oversized piston rings.

Parts Information

Part Number: 88894299
Description: Ring Kit, Piston
Quantity: 8

GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer". They are written to inform these technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions, and know-how to do a job properly and safely. If a condition is described, DO NOT assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See your GM dealer for information on whether your vehicle may benefit from the information.

© Copyright General Motors Corporation. All Rights Reserved.

Frederik
  Zitieren


Nachrichten in diesem Thema
Ölsprenkel am Heck - von Jürgen LS1 - 13.06.2002, 19:24
RE: Ölsprenkel am Heck - von SwissVette_Joe - 13.06.2002, 20:20
[Kein Betreff] - von Jürgen LS1 - 13.06.2002, 20:46
[Kein Betreff] - von Jochen - 13.06.2002, 22:58
RE: - von SwissVette_Joe - 13.06.2002, 23:15
RE: - von SwissVette_Joe - 14.06.2002, 00:25
[Kein Betreff] - von 454Big - 14.06.2002, 01:15
[Kein Betreff] - von Jochen - 14.06.2002, 01:27
[Kein Betreff] - von Jürgen LS1 - 14.06.2002, 09:39
[Kein Betreff] - von Frank - 14.06.2002, 10:59
[Kein Betreff] - von andy - 14.06.2002, 11:12
RE: RE: - von Michael Hoppe - 14.06.2002, 18:43
[Kein Betreff] - von Jochen - 18.06.2002, 12:13
RE: Ölsprenkel am Heck - von SwissVette_Joe - 18.06.2002, 13:33
[Kein Betreff] - von Jochen - 19.06.2002, 00:17
RE: - von SwissVette_Joe - 19.06.2002, 01:32
[Kein Betreff] - von Jürgen LS1 - 19.06.2002, 11:30
[Kein Betreff] - von erik - 19.06.2002, 11:37
RE: - von SwissVette_Joe - 19.06.2002, 12:23
[Kein Betreff] - von erik - 19.06.2002, 12:39
RE: - von SwissVette_Joe - 19.06.2002, 12:59
[Kein Betreff] - von erik - 19.06.2002, 13:18
RE: - von SwissVette_Joe - 19.06.2002, 14:35
RE: - von SwissVette_Joe - 19.06.2002, 16:43
[Kein Betreff] - von Jochen - 19.06.2002, 23:01
RE: - von C5 Frederik - 25.06.2002, 17:28
[Kein Betreff] - von schlafmützerl - 25.06.2002, 20:19
[Kein Betreff] - von hdako - 25.06.2002, 20:35
[Kein Betreff] - von corvettemike - 27.06.2002, 10:36
[Kein Betreff] - von Felix - 30.06.2002, 12:16
RE: - von SwissVette_Joe - 01.07.2002, 02:14
Ölsprengel am Heck - von HK-Vette - 24.07.2002, 19:40
[Kein Betreff] - von corvettemike - 26.07.2002, 10:10
[Kein Betreff] - von HK-Vette - 26.07.2002, 10:50
[Kein Betreff] - von Vmax - 27.08.2002, 12:22
Ölsprenkel am Heck - von SwissVette_Joe - 27.08.2002, 14:22
[Kein Betreff] - von Vmax - 27.08.2002, 14:43
Schmiersäfte aus USA - von SwissVette_Joe - 27.08.2002, 15:20
[Kein Betreff] - von Vmax - 27.08.2002, 15:35
Geografie.......... - von SwissVette_Joe - 27.08.2002, 15:46
RE: Geografie.......... - von Vmax - 27.08.2002, 17:06
RE: Geografie.......... - von SwissVette_Joe - 27.08.2002, 20:04

Möglicherweise verwandte Themen...
Thema Verfasser Antworten Ansichten Letzter Beitrag
  Feindkontakt am Heck Dolsch 36 11.341 05.02.2025, 11:15
Letzter Beitrag: Molle
  C5 Kennezicheneinstatz Heck gesucht! TIPPS ? 50thMirco 7 6.354 25.01.2017, 11:56
Letzter Beitrag: Legend32
  Klappern im Heck bei unebener Strasse flugobst 0 2.653 19.04.2015, 07:47
Letzter Beitrag: flugobst
  Ölrauch am Heck Seapilot 4 3.807 14.04.2014, 21:18
Letzter Beitrag: Seapilot
  Was ist das für ein Heck? furious 3 4.036 18.04.2013, 09:35
Letzter Beitrag: RainerR

Gehe zu:


Benutzer, die gerade dieses Thema anschauen: 1 Gast/Gäste
Forenübersicht
Technikforen
-- C 1 Technikforum
-- C 2 Technikforum
-- C 3 Technikforum
-- C 4 Technikforum
---- C4 ZR-1 Technikforum
-- C 5 Technikforum
---- C5 Z06-Technikforum
-- C 6 Technikforum
---- C6 Z06-Technikforum
---- C6 ZR1-Technikforum
-- C7 Technikforum
---- C7 Z06 Technikforum
-- C8 Diskussionsforum
-- Tuningforum
-- Allgemeines Technikforum
---- OBD2
Other Vette-Stuff
-- Man sieht sich
---- Nachbetrachtungen
---- Stammtische Deutschland
------ Baden-Württemberg
------ Bayern
------ Berlin/Brandenburg
------ Hessen
------ Nordrhein- Westfalen
------ Niedersachsen/HB/HH
------ Rheinland-Pfalz
------ Sachsen
------ Thüringen
------ Schleswig Holstein
---- Stammtische Österreich
------ Wien / St. Pölten
---- Stammtische Schweiz
------ Ostschweiz/Vorarlberg
------ Treffen Schweiz
-- Jäger & Sammler
-- Vettetalk
---- Reiseberichte
-- Corvette-Bilder der Mitglieder
---- Membervideos
-- Sonstige Schöne Vettepics
---- Corvettevideos
-- Vettelady's Corner
-- Wissenswertes & Kurioses
-- Werkstätten & Händler
-- CORVETTE & Parts - For Sale!
---- laufende Auktionen bei EBAY
---- Transporthilfeforum
---- for sale - Alles ohne Corvette!
-- Wanted !
-- Wer weiß was
---- Fragen vor dem Kauf
-- Paragraphen & Pamphlete
Smalltalk und Forumsschnack
-- Über dieses Forum
---- Teammitteilungen
---- In Memoriam
-- Hallo, ich bin's!
-- Motorsport
-- Off Topic
---- Jux & Dallerei
---- Das Club-Forum
---- Don't feed the troll!
-- Glückwunsch- und Grußforum
-- Bits und Bytes
-- Comic-Forum
-- Das Modellautoforum
-- Testforum
Händlerangebote
-- Info-Forum
-- ACP Euskirchen
-- Dyno-Center
-- KTS American Parts
-- Corvetteproject (Molle)
-- Schmidt Revolution
-- NCRS Central Europe
-- IDP-CORVETTE ( INJA )
-- TIKT Performance Parts
-- BG Sportwagen
-- DLP-KFZ-Design
-- Import Factory
-- SPEEDSTYLE
-- V8Lounge
-- AVI Schilling & Wendt Assekuranzmakler
-- Autosalon am Park GmbH
-- NCRS Central Europe
-- Hoffmann Classics
-- CCRP Austria
-- RockAuto.com
-- Stingrays-Shop.com
-- corvetteparts.de
-- Motorentechnik Brunner